Elite AH110 6" Power V-Wheel — sold singly. Solid steel, gold zinc plated, with sealed ball bearings. This is the load wheel a sliding or rolling gate rides on, running in the V of an inverted angle-iron track. The 6 in. wheel is the heavier-duty option; for lighter gates see the 4 in. AH108 single or AH107 pair.
| Wheel diameter | 6 in. |
| Material | Solid steel, gold zinc plated |
| Groove | V-groove, for inverted angle-iron track |
| Overall height | 5-13/16 in. |
| Width | 1-3/4 in. |
| Bore | 5/8 in. |
| Bearings | Ball bearings, sealed |
| Axle | 5/8 x 3 in., included |
| Quantity | Single wheel |
Check the bore before you order. Measure the axle on the wheel you are replacing. This wheel takes a 5/8 in. axle; the 4 in. Elite wheels take 1/2 in. A 6 in. wheel also needs more clearance between the gate frame and the track than a 4 in.
When to replace them. Worn V-wheel bearings are the usual cause of a sliding gate that grinds, judders or drags as it travels, and of a gate that sits low at one end. Replace wheels in pairs so the gate stays level and the load stays even — order two of these.
What else you may need. If the brackets are rusted or you are hanging a new gate, add V-wheel mounting plates. For the full range of wheels, guide rollers, catches and drive chain, see sliding gate hardware.
