Liftmaster KPW5 & KPW250 Access Control Parts

LiftMaster KPW5 and KPW250 wireless keypad replacement parts diagram

LiftMaster KPW5 & KPW250 Replacement Parts

Genuine LiftMaster replacement parts for the KPW5 and KPW250 wireless keypads — the battery-powered Security+ 2.0 keypads that open a gate or door without running wire to the entry point. Use the diagram above to find the key number for the part you need, then click any part number in the table below.

KPW5 or KPW250? The KPW5 is the charcoal residential unit holding up to 5 codes; the KPW250 is the silver commercial unit holding up to 250. They are otherwise the same keypad, and the rear housing and keys fit both.

Not working after a while outdoors? These run on a 9V battery behind the battery cover. Change the battery before ordering anything — a flat battery is by far the most common cause of a dead keypad.

The battery and battery cover are not sold separately. Only the rear housing and the replacement keys are available as service parts; if the front housing or keypad itself has failed, the unit is replaced rather than repaired.

Common KPW Faults

Symptom Usual cause Parts to check
Keypad completely dead Flat 9V battery Change the battery first — a standard 9V
Works intermittently, worse in cold Battery near end of life Fit a fresh 9V battery
Water inside, corrosion on the contacts Rear housing cracked or seal failed K093A0763 rear housing
Keys lost or the lock will not turn Replacement keys needed K107A0031 replacement keys
Codes accepted but the gate does not move Not the keypad — check the operator receiver Verify the operator responds to a remote first
Buttons unresponsive with a good battery Front housing and keypad assembly Replace the unit — KPW5 or KPW250

Keypad Repair & Service Parts

Ref Part # Description
1 KPW5 Wireless Keypad, Charcoal
1 KPW250 Wireless Commercial Keypad, Silver
2 K093A0763 Rear Housing, KPW5 / KPW250
4 K107A0031 Replacement Keys, KPW5 / KPW250